Watch Videos Online

How to Configure DHCP on a Cisco Router



CertBros Education 2016-03-09 - 21:00:00

"How To Configure DHCP On A Cisco Router This Video will show you how to configure DHCP server on a Cisco Router. It’s pretty simple to configure DCHP,, just a few lines are your all set! Below is the commands to configure DHCP. I will explain what each one means further down. service dhcp – Tells the router to turn on the DHCP service. ip dhcp pool MAIN-POOL – Adds a DHCP pool named ‘MAIN-POOL’. The name can be changed to whatever you like. network 192.168.1.0 255.255.255.0 – Tells the router to use the IP addresses within the 192.168.1.0 network which is any address between 192.168.1.1-192.168.1.254. default-router 192.168.1.254 – This will be set as the default gateway on the DHCP clients dns-server 192.168.1.1 – This will be set as the DNS server on the DHCP clients ip dhcp excluded-address 192.168.1.254 – This stops DHCP from leasing out this address. ---------------------------------------------------------------------------------------------------------------- 📚 Highly Recommended Study Books! 📚 CCENT (ICND1) 100-105: https://amzn.to/2W2PwkN CCNA (ICND2): 200-105: https://amzn.to/2TKcIrh ---------------------------------------------------------------------------------------------------------------- Do you Even CertBros? Website: http://www.certbros.com Subscribe: https://goo.gl/l999wu Twitter: https://twitter.com/certbros"

provider networks. A router or a residential gateway can be enabled to act as a DHCP server. Most residential network routers receive a globally unique IPinstalled into the routing table. Router# enable Router# configure terminal Router(config)# ip route 1.1.1.0 255.255.255.0 fastEthernet 0/0 Router(config)# domaps, on every router on which it is implemented. The state of a given route in the network is the cost, and OSPF algorithm allows every router to calculatethe router interface IP address from which the RIPv1 response was sent. As the requesting router receives updates from different neighbouring routers it(switch, router, wireless access point, DHCP server, etc.) is configured for NAC, it can force user or machine authentication prior to granting access to therouter. Internal address of router: 192.168.1.1 Address of the server: 192.168.1.2 Address of a local computer: 192.168.1.100 If a packet is sent to theaddress configured incorrectly on either router. AS number configured incorrectly on either router. Active State: If the router was unable to establish a successfuluse of automatic Router Discovery. Therefore, ISATAP hosts must be configured with a potential routers list (PRL). Each of these routers is infrequentlycomputer called a router is provided with an interface to each network. It forwards network packets back and forth between them. Originally a router was calledfinal (local) router. This router then broadcasts the packet using layer 2 broadcast. This technique allows a broadcast to be initiated on a remote network



Sign up to our newsletter

Don't miss any trending posts!